Vision Controls Cam SS Version 5.01 Manual de instrucciones Pagina 29

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 76
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 28
Installing In-Sight
®
5000 Series Vision Sensors
15
3. Verify that the 24VDC supply is not receiving power, then connect the power supply to the
Breakout cable (
Figure 3-4). Attach the Breakout cable to the 24VDC connector on the
sensor.
Figure 3-4: Power Connections
NOTE:
Unused bare wires can be clipped short or tied back using a tie made from non-conductive
material. Keep all bare wires separated from the +24VDC (White/Green) wire.
!
CAUTION: Never connect voltages other than 24VDC. Always observe the polarity
shown.
Vista de pagina 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 75 76

Comentarios a estos manuales

Sin comentarios