Vision Controls Cam SS Version 5.01 Manual de instrucciones descargar pdf (Pagina 44)

43 / 69

http://www.toshiba-teli.co.jp/index.htm

D4211908A

● Registers

Description

TriggerSelector Beginner R Returns the type of trigger.

TriggerMode Beginner R/W Selects Random Trigger Shutter mode.

TriggerSoftware Beginner W Executes software trigger.

TriggerSource Beginner R/W Selects trigger source of Random Trigger Shutter.

TriggerActivation Beginner R/W Selects trigger polarity of hardware trigger.

TriggerDelay Expert R/W Sets trigger delay.

● Setting

- Selects trigger mode

Set the following value to “TriggerMode” register. Setting value is Enumeration type.

setting value Operation Mode

Off (*) Normal Shutter Mode

On Random Trigger Shutter mode

* initial factory setting

- Selects trigger source

Set the following value to “TriggerSource” register. Setting value is Enumeration type.

setting value Trigger source

Line0 (*) Hardware trigger

Software Software trigger

* initial factory setting

- Grabs image stream by software trigger

When executes “TriggerSoftware” register command, software trigger command is generated. And the

camera starts exposure by receiving software trigger command in software trigger mode

- Changes trigger polarity (HardwareTrigger operation only)

Set the following value to “TriggerActivation” register. Setting value is Enumeration type.

setting value Polarity

FallingEdge (*) Negative

RisingEdge Positive

* initial factory setting

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 70 71

Sin comentarios

Vision Controls Cam SS Version 5.01 Manual de instrucciones Pagina 44